Jawas Junkyard

Odin's Wrath V3 - Elite Chassis Group Buy

USD200

This is the Odin's Wrath V3, Elite Chassis Group Buy.

The chassis was designed by Sam of Shadowfoil props.

The preorder for group buy chassis will be open for one week! Then I will close it and place the group order. 

Pre orders are open from today 7/6/2023 10pm and will close in one week, 14/6/2023 (AEST).

This item is for a chassis ordered direct with a 3D printing service. As such it will take a few weeks from order placement to being able to ship. So it will need to ship as a separate item.

The chassis has 8 parts.

1 part is to be machined brass. 2 parts are 3D printed steel. Then there are 3 Nylon printed parts (to hold your electronics parts) and finally 2 clear resin printed parts.

 

Designed to work with a short pin pixel connector (17.5mm OD).

2x 8mm pixel pcbs (these will be custom made and included.)

20.5mm OD rotary connector (not included)

28mm, ayima bass speaker (any bass speaker) (not included)

4x brass tube 4mm OD 34.5mm long (not included)

18650 Button Top Protected.

7x M3x3mm set screws (Not included) - You will need an M3 tap to secure some parts together.

1x4mm pixel accent (optional) - available from shadowfoil's etsy page.

keystone 1010-1 and 1016-1 battery tabs

Please note that this will require some work, sanding polishing for fit and finish. 
Some personal notes from my own install. The way the chassis is designed, it's tempting to route all your wires from the switches/crystal chamber and battery in the top portion first. But please, don't do this (like I did). You will ended up with excessive wire length that you cannot hide at the end. Also, for your pixel accents, and switches, please use as small wire as possible to better manage it all. 
Please see exploded view:
Open photo


No electronics are included other than what I have specifically said is included.

All shop policies are applicable to this listing and you must read and understand these before purchasing.

Recently viewed