Jawas Junkyard

Karre - Chassis Group Buy


This is the Karre Chassis preoder. The preorder for group buy chassis will be open for one week! Then I will close it and place the group order. After that, you can order it as a print my home print (nylon but not SLS print method). 

Designed by our good friend Tim over at Tierfon Orbital. This chassis is designed to have a reveal crystal chamber right under the opening control box. It also holds a magnet to keep the control box closed.

The chassis is an "eco" chassis, designed to make DIY install easy.

Pre orders are open from today 7/10/2023 9pm and will close in one week, 14/10/2023 (AEST).

This item is for a chassis ordered direct with a 3D printing service. As such it will take a few weeks from order placement to being able to ship.

The chassis has 4 parts.

1. Main chassis:

Printed in black nylon using SLS technology.

Designed to hold proffie v2.2. 18650 protected li-ion battery, removeable battery system via two keystone battery tabs and a 28mm base speaker. 

It also holds a SHTOK or CCSabers neopixel adaptor and is fully removeable.

2. Pommel speaker spacer.

 Printed in black nylon using SLS technology. 

Designed to keep a good sound venting volume at the bottom of the hilt, and ensuring a tight fit chassis once the pommel is installed.

3. Switch Extension.

This piece is printed and glued onto the rocker. This allows the rocker to directly push a switch on the removeable main chassis. It's not the neatest of designs, but it's a consequence of the opening control box. 

4. Printed Synthetic Crystal

Printed in a translucent red resin.

Designed to be lit in the chassis and visible in the reveal.

No electronics are included. 

All shop policies are applicable to this listing and you must read and understand these before purchasing.

Recently viewed