Jawas Junkyard

The Teenage Dirtbag - Chassis Group Buy

USD55

Finally opening the Teenage Dirtbag Chassis preoder. The preorder for group buy chassis will be open for one week! Then I will close it and place the group order. After that, you can order it as a print my home print (nylon but not SLS print method). 

The chassis is an "eco" chassis, designed to make DIY install easy.

Pre orders are open from today 22/4/2024 1pm AEST and will close in one week, 29/4/2024 11:59pm (AEST).

This item is for a chassis ordered direct with a 3D printing service. As such it will take a few weeks from order placement to being able to ship.

The chassis has 3 parts.

1. Main chassis:

Printed in black nylon using SLS technology.

Designed to hold proffie v2.2. 18650 protected li-ion battery, removeable battery system via two keystone battery tabs and a 28mm base speaker (may require sanding to fit), kill switch.

This is partially removeable via a fixed section (what you normally see with thin neck builds).

2. Static Component.

 Printed in black nylon using SLS technology. 

Designed to be held in place at the top of the main body of the hilt. Holding a chassis adaptor from SHTOK or CCSabers. This takes wires upto the blade holder cup for the pixel blade.

3. Pommel spacer for the speaker. 

Printed in black nylon using SLS technology.

No electronics are included. 

All shop policies are applicable to this listing and you must read and understand these before purchasing.

Recently viewed